Campbell Hausfeld GN3565V - Manual

Assembly
NO TOOLS REQUIRED FOR ASSEMBLY
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
1
IN216502AV 5/98
Operating Instructions Models GN2560V, GN2563V, GN3560V and GN3565V
Generators
CAMPBELL
HAUSFELD
Description
These generators are powered by air-
cooled four cycle engines and designed
to run at maximum RPM and give a
continuous wattage as rated.
Unpacking
When unpacking, inspect carefully for
any damage that may have occurred
during transit. Make sure any loose
fittings, bolts, etc., are tightened before
putting unit into service.
General Safety
1. Before starting or
servicing any
generator, read and
understand all
instructions. Failure
to follow safety precautions or
instructions can cause equipment
damage and/or serious personal
injury. Engine instructions for these
units are contained in a separate
manual. Retain all manuals for
future reference.
2. Never use this generator for any
application other than that specified
by the manufacturer. Never operate
this generator under conditions not
approved by the manufacturer.
Never attempt to modify this
generator to perform in any manner
not intended by the manufacturer.
3. For maintenance and repairs, use
only products and parts
recommended by the manufacturer.
4. Be sure that the generator is
operated only by persons who have
read and understand these
instructions.
5. Keep all persons away from the
generator during operation.
6. Keep the generator clean and well
maintained at all times.
Shut off the
generator engine
and disconnect the spark plug wire
before performing any service or
maintenance to the unit.
8. Use only unleaded fuel. Do not refill
the fuel tank while the engine is
running. Use precautions to prevent
fuel spillage during refills. Be sure
the fuel tank cap is securely in place
before starting the engine. Allow
engine to cool for at least two
minutes before refueling.
Never mix oil with
gasoline for this
engine. Oil is used for engine lubrication
purposes only.
MANUAL
Fig. 1 Assembled Unit GN3560V
Fig. 3 Handle Assembly
Fig. 2 Assembled Unit GN2560V