Sony SAT-A3 - Manual (Page 102)

Find the elevation of the satellite:
Use the elevation coordinate you r^orded from the map to find the
elevation of the satellite. Finding the elevation, or angle, of the
satellite enables you to choose an installation site that has an
unobstructed view of the satellite.
1
Locate three reference points to help you estimate the location
of the satellite:
□ 0° — located at the horizon in front of you.
□ 90° — located directly above you.
□ 45° — located midway between 0° and 90°.
Use the elevation coordinate you recorded and these three
reference points to estimate the elevation of the satellite.
Note
• The position of the satellite in this illustration corresponds to the 45°
elevation from the example on page 7.
60°
Satellite
90°
25°,
45°
You should now be able to poirit to thè approximate location of the
satellite. Use this information when you choose an installation site
for the antenna.
You now know where the satellite is located in the sky. Keep the
location in mind as you look around your property for a good place
to install the antenna. Use the following suggestions to ease the
installation and extend the life of the antenna:
□ Keep a clear view — avoid areas where trees, buildings and
roof overhangs interfere with the satellite signal. Also
consider the effects of future tree growth or building
construction.
□ Protect the antenna — avoid installing the antenna where it
can be bumped or jarred by people, furniture, doors or pets.
Also avoid installing under gutters, due to the possibility of
icicles or ice buildup.
□ Simplify the installation — try to avoid an installation that
requires the use of a ladder.
□ Choose a sturdy site — windy conditions can generate several
hundred pounds of pressure on the base plate. To avoid
problems, choose an installation site that is structurally sound
and able to withstand severe storm conditions.
□ Choose an accessible site — if snow falls where you live, you
will need to brush the snow off the antenna.
□ Locate the antenna close to the receiver — cable run should be
100' or less. If more than 100', you must use Sony brand DSS
Amplifier EAC-DAl.
Where to Install the Antenna
This manual provides instructions for installing the antenna on
several surfaces:
□
□ Metal Pole
Wood
□ Brick
□ Cinder Block
Read through the rest of the manual before you begin installing the
antenna. Planning the installation will save you time and help you
avoid mistakes.
8