Sony SAT-A3 - Manual (Page 81)

Using the Remote Control
The FUNCTION buttons flash to indicate
which component the remote control is set
to operate.
After you've installed the batteries and programmed the remote
control, use these procedures to operate your system components;
1
Select the component that you want to’use; To operate a cable box,
TV, or the DSS receiver, press the corresponding FUNCTION
button.
SAT-A3 Only: To operate a VCR or laserdisc player, open the lid on
the remote control and set the slide switch to the position that you
set for the component.
2
Aim the remote control at the component.
3
Press the POWER button of the component to turn it on and off.
To control other functions of the component, see the table that follows.
SAT-A3 Remote Control
Outside Panel (SAT-A3)
Note
Buttons described in the following table can operate components other than the
DSS receiver only if you've programmed the remote and the component
supports the function described. See page 85 for instructions on programming
the DSS remote.
Button Operates Description
MUTING
O
TV Mutes the volume. Press again to restore the
volume.
SLEEP
O
TV Automatically turns off the TV, after the time
period that you specify.
--------------- POWEF
VTR TV
I----------------
DSS
CABLE: Turns the cable box on and off.
CD O
o
TV: Turns the TV on and off.
DSS: Turns the DSS receiver on and off.
FUNCTION -------- CABLE TV DSS
CABLE: Puts the remote in cable mode. In cable
((—^ (~Si mode, the remote operates your cable box.
TV: Puts the remote in TV mode. In TV mode,
the remote operates your TV.
DSS: Puts the remote in DSS receiver mode. In
DSS'modS, the remote operates your DSS
receiver.
TV/VIDEO
Q
TV Switches the input of the TV.
TV/DSS
O
DSS Switches the output of the DSS receiver to TV
(normal TV programs), if you've connected a
TV cable or antenna, or to DSS programs.
Appendix: Other information 81