Sony SAT-B1 - Manual (Page 65)

Programming the Remote
You must perform step 4 within 10
seconds of step 3, or you must start
again from step
3.
You must perform step 5 within 10
seconds of step 4, or you must start
again from step 3. To cancel the
operation, press the EXIT button.
The DSS receiver's remote control is preset at the factory to operate
Sony brand TVs.
If you have a TV other than Sony brand, or you have a cable box you
want to control with the DSS receiver's remote, use the following
procedures to program the remote to control these components.
Note
Your components must have infrared (IR) remote control capability in order to
be used with the DSS receiver's remote.
To program the DSS receiver's remote:
1
Manually turn on the component that you want to program.
2
Turn to "Programmable Codes" on page 71, and find the three-
digit code number for your component. If more than one code
number is listed, use the number listed first to complete the
following procedures.
3
Press the CODE SET button.
4
Press the FUNCTION button (CABLE or TV) for the component
you're setting up.
5
Enter the three-digit code number.
6 Press the ENTER button.
To Check if the Code Number Works
Use the following procedure to make sure the code you've entered
works:
1
Aim the DSS receiver's remote at the component and press the
POWER button that corresponds to that component.
2
If the component responds, try the CH+ and CH- buttons. If the
component responds, you're done. Use the space below to record
the code numbers for your components.
TV Code
If the code doesn't work:
□
Cable Box Code
Try programming the remote using the other codes listed for your
component.
□ If you cannot get your component to respond to the DSS receiver's
remote — even after trying all the code numbers for your
component — your component may not be compatible with the
DSS receiver's remote. If this happens, you must use your
component's own remote to operate it.
70 Appendix: Other Information