Locating a track (ams*/direct access), Locating a point (shuttle play/ mark & locate), Do the following – Sony PCM-R500 User Manual
Page 17: Q' playback speed during shuttle play, Note, Advanced playback operations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced Playback Operations
Locating a Track (AMS*/Direct
Access)
You can locate the tracks in a number of ways, but only
after you have recorded start IDs on the tape (see pages
19 to 23). To use Direct Access, program numbers
must be recorded on the tape (see pages 19 and 23).
Locating a Point (Shuttle Play/
Mark & Locate)
You can locate a specific point by playing back at a
different speed or recording the absolute time code at
the point to be located later.
PREVIOUS I
I/NEXT I
PLAY I
To locate
Do the following:
The beginning of the next
or succeeding tracks
(AMS)
Press NEXT as many times
as you want while playing. For
example, to locate the second
track ahead, press twice.
The beginning of the
current track (AMS)
Press PREVIOUS once
while playing.
The beginning of
preceding tracks (AMS)
Press PREVIOUS as many
times as you want while playing.
For example, to locate the second
track behind, press three times.
By specifying the
program number of a
track (Direct Access)
1
While the deck is playing or
stopped, turn DATA on'the
front panel until the program
number you want appears in
the display (or enter the
program number with the
number buttons on the remote).
2
Press PLAY ► .
* AMS = Automatic Music Sensor
If you enter the wrong program number during
Direct Access
If you haven't pressed the PLAY ► button, turn the
DATA dial on the deck (or press the CLEAR button,
then enter the correct number on the remote).
If the deck detects a blank section of 9 seconds or
more, end ID, or the end of the tape
The deck rewinds the tape automatically to its
beginnirtg and stops (Auto Rewind).
y You can make the deck start playing automatically
from the beginning of the tape after rewinding
(Auto Play)
Press the PLAY ► button while holding down the
REW button.
LOCATE MARK
SHUTTLE
To locate
Do the following;
A track using variable
speed play (Shuttle Play)
While the deck is playing, stopped,
or paused, turn SHUTTLE.
• If the deck was playing or
stopped, the deck starts to play
when you release the SHUTTLE
dial.
• If the deck was paused, the deck
pauses when you release the
SHUTTLE dial.
A particular point on a
tape (Mark & Locate)
While the deck is playing or
stopped, press MARK. The
absolute time of the point
where you pressed the button
appears and flashes three
times.
Press LOCATE. The deck
locates the point and stops.
Q'
Playback speed during Shuttle Play
During Shuttle Play, you can vary the playback speed
from ±0.5 to ±8 times the normal playback speed (or ±1
to ±8 times the normal playback for material recorded
in long-play mode), depending on the angle and
direction of the SHUTTLE dial. Turn the dial clockwise
for forward playback or counterclockwise for reverse
playback.
The playback speed will be ±8 times normal speed
playback when you turn the dial to the left or right
fully.
Note
Shuttle Play should be used only when necessary since
prolonged use may damage the tape and drum.
Q The point memorized using the Mark & Locate
function will be erased when:
— you take out the cassette.
— vou turn off the deck.
17
'