Writing skip ids during recording, Writing skip ids manually during recording, Writing sub codes during playback – Sony PCM-R500 User Manual
Page 21: Writing sub codes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Writing Sub Codes
Writing Skip IDs During
Recording
SKIP ID WRITE
Writing skip IDs manually during recording
Press SKIP ID WRITE.
"ID WRITE" appears in the display for a few seconds
and the skip ID is written on the tape. "SKIP ID"
flashes in the display during this time.
I D i i ) R I T E
Writing Sub Codes During
Playback
You can write start IDs or skip IDs during playback.
START
ID
START
ID
REHEARSAL WRITE
1 1
a a la ai a □
© □ 1 ■ i?i h n
SKIP ID
REHEARSAL
SKIP ID
WRITE
REW -«/FF I
Press START ID WRITE or SKIP ID WRITE.
"ID WRITE" appears in the display for a few seconds
and the specified ID is written on the tape at the point
you pressed the button.
Accurate positioning of sub codes
(Rehearsal function)
1
During playback, press REHEARSAL
corresponding to the ID you want when you
arrive at the proper position.
"REHRSL" appears, the corresponding ID
indication flashes in the display and the Rehearsal
function repeats a 3-second portion containing the
selected position. The repeated portion plays
back 8 times, with the remaining number of times
appearing to the right of the "REHRSL". After 8
times, the deck stops.
In the case of a start ID, the 3-second repeated
portion starts from the point where you pressed
the REHEARSAL button.
In the case of a skip ID, the 3-second repeated
portion ends at the point where you pressed the
REHEARSAL button.
Press REW ◄ ◄ or FF ► ► to move the beginning
of the repeated portion.
Each time you press the REW ◄ ◄ or FF ► ►
button, the beginning of the repeated portion
shifts bacTcwards or forwards in 0.3-second
increments, up to a maximum extent of about 2
seconds (4 seconds in long-play mode) in either
direction.
(Continued)
2 1 '