Rack mounting, Inserting batteries into the remote, Before using the remote – Sony PCM-R500 User Manual
Page 4: Q' when to replace the batteries, Notes, Unpacking rack mounting, Getting started
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Unpacking
Rack Mounting
Check that you have received the following supplied
items:
• AC power cord (1)
• Remote commander (remote) RM-D757 (1)
• Size-AA (R6) batteries (2)
• Screws (M5xl2) (4)
• Decorative washers (4)
• Operating instructions (1)
Inserting batteries into the remote
Insert two size-AA(R6) batteries, matching the + and -
on the batteries with the markings inside the battery
compartment.
You can install your deck in a 19-inch 3U-size rack. Be
sure to disconnect the deck from the wall outlet before
you install it.
1
Remove the four feet from the deck.
2
Insert the deck into the rack and secure it with the
supplied decorative washers and screws (M5xl2).
Before using the remote '
Set REMOTE on the front panel to WIRELESS.
REMOTE
WIRED OFF WIRELESS
'Q' When to replace the batteries
With normal use, batteries should last for about 6
months. When the remote no longer operates the deck,
replace both batteries.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign matter into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
illumination as doing so may cause malfunction.
• When not using the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Note
Do not reattach the screws directly after removing the four
feet. Put the screws and the feet in a safe place for
reattachmenrtn the future. Using longer or shorter screws ■
may damage the internal circuit board.