Sony SS-RC301 - Manual (Page 9)

Getting Started
After connecting all the components, speakers and AC
power cord, output a test tone to check that all the
speakers are connected correctly. For details on
outputting a test tone, refer to "Adjusting the speaker
volume", on page 18.
If you have connected rear speakers, be sure to press
the 5.1 CH/DVD button and turn off sound field on
the receiver before outputting a test tone so that the
tone is output individually from the left and right rear
speakers.
If no sound is heard from a speaker while outputting a
test tone or a test tone is output from a speaker other
than the one whose name is currently displayed on the
receiver, the speaker may be short-circuited. If this
happens, check the speaker cormection again.
Active woofer
Receiver Active Woofer
Selecting the speaker system
To drive the speakers, select the speaker system as
follows:
To drive Depress SPEAKERS button
Speaker system A (connected
to the SPEAKERS FRONT A
terminals)
A
Speaker system B (connected
to the SPEAKERS FRONT B
terminals)
B
Both speaker systems A and
B (series connection) A+B
Notes
• If you want to enjoy the surround sound, be sure to
connect the front speakers to the SPEAKERS FRONT A
terminals.
• No sound is heard when you press SPEAKERS A + B
without connecting speaker system B.
Where do / go next?
To complete your system, go to "AC Hookups" on page 10.
Note
Do not connect any other componet.
'Q' If you have an additional front speaker system
Connect them to the SPEAKERS FRONT B terminals.
'Q' If your TV monitor uses separate speakers
You can connect one of them to the SPEAKERS
CENTER terminals for use with Dolby Pro Logic
Surround sound (see page 17).