Manufacturer code numbers (cable box), Manufacturer code numbers (satellite receiver), To operate the projection tv – Sony KP 61S70 User Manual
Page 49: Setting the manufacturer's code, Operating a cable box or satellite receiver (sat)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Operating a Cable Box or Satellite Receiver (SAT)
Setting the Manufacturer's
You Ccin progiMin tlio suppliod remote control
to operate a cable box or satellite receiver.
Press CODE SET, SAT/CABLE
(FUNCTION), and the 0-9 buttons to enter
the manufacturer's code number (see the
following chart), then press ENTER.
Eor exam pie, to operate a Sony satellite recei\'er:
CODE SET SAT/CABLE
222, 223, 224, 225, 226
222, 206, 207, 208, 218‘
227, 228, 229
219, 220, 221
209, 210, 211
801 (preset code for
To operate the cable box or
satellite receiver (SAT)
Press SAT/CABLE (POWER) [Green
Button] to turn on/off the cable box or
Press SAT/CABLE (FUNCTION).
For other operations, refer to the
operating instructions that come with the
The GUIDE and INDEX (blue-labeled)
buttons can be used only with a satellite
If the remote control doesn't work
• Try repeating the set up procedures using
the other codes listed for your equipment.
To operate the projection TV
Press TV (FUNCTION). Then use the
projection T\' control buttons to control the
If imur llhiii oiw code number Ì, Hik’d, In/ eufcriiig
Ihciii one by one until you conic lo the correct code
tor your equipment.
If you enter a new code number, the code number
tfou prcviouily entered ut tliut setting is erased.
In some rare cases, you may not be able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
Whenever you remove the batteries
them, for example
if too much time is taken, the
code numbers may revert to the factory setting and
must be reset.