Returning to a pre-registered position, Ccd-trv99 only, Notes on the tape counter – Sony CCD-TRV95 User Manual
Page 74: Notes on zero mem, Ccd-trv99 only)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Returning to a pre-registered position
- CCD-TRV99 only
Using the Remote Commander, vou can easily go back to the desired point on a tape
after playback. Use the tape counter. If the RC time code appears, set COUNTER to
NORMAL in the menu system to display the tape counter.
(1) During playback, press COUNTER RESET at the point you later want to locate.
The counter shows "0:00:00".
(
2
) Press ■ when you want to stop playback.
(3)
Press ZERO MEM on the Remote Commander. The ZERO MEM indicator
flashes.
(4)
Press to rewind or press ►► to fast-forward the tape to the counter's zero
point. The tape stops automatically when the counter reaches approximately
zero.
>
Q.
Notes on the tape counter
• Something must be recorded on the tape in order for the tape counter to function.
Tape counter does not work on a blank tape.
• There may be a discrepancy of several seconds from the actual time.
Notes on ZERO MEM
• When you press ZERO MEM, the counter's zero point is memorized. Press ZERO
MEM. again before rewinding to cancel the memory.
• This function is cancelled automatically once the tape is rewound or advanced to the
point you pre-registered.
• ZERO MEM does not function during recording or playing back.
71