Recording from a vcr or tv, Replacing recording on a tape - insert editing, Ccd-trv99 only – Sony CCD-TRV95 User Manual
Page 83: To change the end point
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Recording from a VCR or TV
Replacing recording on a tape - Insert Editing
- CCD-TRV99 only
You can insert a new scone from a VCR onto your originally recorded tape by
specifying starting and ending points.
Connections are the same as in "Recording from a VCR or TV".
(
1
) While pressing the small green button on the POWER sw'itch, set it to VTR.
(
2
)
On the VCR, locate the start point to be inserted aiud set it to playback pause
mode.
(3)
On the camcorder, locate the point where the insert should end by pressing
◄◄ or ►►, then press II to set it to playback pause mode.
(4)
Press COUNTER RESET to set the counter to zero.
(5)
On the camcorder, locate the point where the insert should begin by pressing
then press # REC and II to set it to recording pause mode.
(
6
)
Press ZERO MEM. The ZERO MEM indicator flashes and the end point of the
insert is stored in memory.
(7)
Press
II
on the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the zero point on the counter.
To change the end point
Press ZERO MEM so that the ZERO MEM indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of fhe inserfed portion when it is played back.
80