Setting up and tuning the modulator – Sony MRD-D1 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting up and Tuning the Modulator
Perform the following steps after your multi-room distribution system
has been connected properly.
1
Connect the output (mini-jack) of the power supply to the modulator
unit and plug the power supply into a 110 V AC wall outlet.
The green LED Power indicator should illuminate. If it does not,
recheck all power connections.
2
Turn on the main TV. The mode of your TV (CATV or antenna)
will determine the "in-house" channels you will use.
□ If antenna, you will use UHF channels between 14 and 35
inclusively.
□ TF cable, you will use CATV channels between 54 and 86
inclusively.
Refer to your notes made of channels delivered to your home
(page 7).
3
Select your "in-house" channels and make a written note of what
they will be. Select a charmel for the second video source even if
one will not be used.
□ For CATV: use channels higher than that of your notes.
Highest Channel
Set INPUT 1
Set INPUT 2
34
54
56
65
67
69
□ For antenna: select any bf the' unused channels provided that
they are at least one unused channel apart from one another and
at least one unused channel away from a channel with a picture.
Highest Channel
Set INPUT 1
Set INPUT 2
15,16,17, 20,
24,25,26
16
26
14,15,19,20, 21
14
20
Installation Instructions 11