Note – Sony MRD-D1 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fasten the modulator unit to the desired location using the
mounting screws provided with the unit. The orientation is not
critical. Mounting that enables clear access to the top of the unit for
tuning and easy access to connectors on the left and right sides of
the unit is most desirable.
Connect the modulator unit to the video sources (when viewed
from the end, the video and audio input cormectors on the left are
for INPUT 1 and those on the right are for INPUT 2).
Connect the DSS receiver video and audio outputs to INPUT 1 and
the second video source (optional) to INPUT 2.
Video
(Yellow)
jmii
1^1
Audio L \anini Ibi
(White) Audio R
(Red)
*
1 ^
z
I- 1
Video
(Yellow)
i=CZBro°<
Audio R
(Red)
Audio L
(White)
7
Connect the coaxial cable from the antenna or the cable source
directly to the modulator unit using the connector labeled RF IN.
8
Connect the main TV to the modulator unit using a coaxial cable
between the VHF/UHF input of the TV and one of the cormectors
labeled LOCAL RF OUT on the modulator unit.
Note
• Whe7t the second video source is a VCR, connect the other LOCAL RF OUT
connector to the VCR input connector using a coaxial cable.
8 Installation Instructions