A warning, Excessive weight hazard, Unpacking – LG LFC25765 User Manual
Page 9: Moving your refrigerator, Explosion hazard, Installation, Once installed, 0 warning, Installation of base grille, Installing the base grille
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EXCESSIVE WEIGHT HAZARD
Use the assistance of two or more persons to move or
install the refrigerator. Not following these instruotions
may oause injury to the baok and other parts of the
that feature warnings, the model serial number or the
teohnioal label of the produet loeated on the bank of the
To remove adhesive tape residue, rub it well with your
fingers and a little liguid detergent. Clean with warm
water and let dry.
Do not use sharp instruments, rubbing aleo hoi, flammable
adhesive tape or glue. These produets ean damage the
surfaee of your refrigerator. For more information, see
the seetion on "Important Safety Instructions"
aeeording to your spaeing needs.
Moving Your Refrigerator;
Your refrigerator is extremely heavy. Make sure you
proteet the floor when moving your refrigerator for
eleaning or servieing. Always pull your refrigerator
straight out when moving it. Do not shift from side
to side or "walk" the refrigerator when attempting to
move it as this ean oause damage to the floor.
Keep all flammable materials and vapors (sueh as
these instruotions may oause death, explosion or fire
1. Avoid planing the unit near heat sources, dirent
sunlight, or humidity.
2. To avoid vibration, the unit should be leveled. If needed,
unleveled floor. The front should be slightly taller than
the rear to ensure that the doors elose properly. The
leveling serews ean easily be turned by slightly tilting
the front of the refrigerator, turning the leveling screws
) to raise it and eounter-eloekwise
) to lower it
3.Install the refrigerator in an area between 55 °F
(13°C)and110°F (43 °C). If the surrounding temperature
is lower or higher than previously mentioned, it ean
adversely affeot the unit
CAUTION; Avoid plaeing the unit near
sources, direst sunlight or humidity.
1. Carefully olean your refrigerator and remove and dust
aooumulated during shipping.
.Install aooessories sueh as the iee bin, door raeks,
shelves, ete., in their proper plaees. These are already
3.Leave your refrigerator on for 2 to 3 hours before
storing food inside. Verify that there is a flow of sold air
in the freezer eompartment to ensure proper eooling.
Your refrigerator is now ready for use.
• Take eare when working with the hinges, base eover
and stops, ete. You may injure yourself.
• DO not plaee your hands or any tools in the air vents,
the base eover or in the bottom of the refrigerator. This
may oause injury or eleetrieal shook.
INSTALLATION OF BASE GRILLE
Uninstalling or Replacing the Base Grille
1. Remove the 2 serews from the bottom front part of
your refrigerator (see Figure A).
. Take off the eover.
Installing the Base Grille
1. Align the bottom eover and plaee in position. Insert
the 2 serews and twist in plaee (see Figure B).
Keep a Proper Distance from Adjacent
increase electricity consumption.
(5.08 cm) 2"