Craftsman 320. 28180 - Manual (Page 22)

MAINTENANCE
vJi,wjti/,p », ■ t ; «¿xi«>.I|
GENERAL MAINTENANCE
WARNING: Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which may result in serious personal injury.
WARNING: Always wear safety goggles or safety glasses with side shields
during power-tool operation or when blowing dust, if the operation is dusty, also
wear a dust mask.
TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
The router does not
work
The router is not plugged
into the table outlet.
Insert router power cord
plug into a table outlet
The router-table cord is
not connected to a power
source
Plug the router-table cord
into a power source
The Router switch is in
“OFF” position.
insert key and pull the
switch to the ON position
The table surface is
not flat
Legs are not properly as­
sembled.
Check assembly directions
and securely tighten ali
fasteners
Work surface is not flat.
Place router table on a fiat,
level surface
The router can not
be attached to the
table
Sub-base is too large
Use a sub-base 6-7/8 in. in
diameter or less.
28180 ManuaLRevlsed_07-€228 Page 22