Craftsman 247.775880 - Manual (Page 5)

ASSEMBLY
• Remove all loose parts Including owner's
manual. See figure 1.
• Roll chipper-shredder out of the carton.
• Make certain all parts and literature have been
removed before the carton is discarded.
LOOSE PARTS
(Refer to figure 1.)
a. Hopper Assembly
b. Discharge Chute
c. Chipper Chute
d. Catcher Bag
e. Bottle of Oil
f. Safety Glasses
g. Owner's Manual (not shown In figure 1)
TOOLS REQUIRED
1. 1/2" or Adjustable Wrenches
2. 7/16" or Adjustable Wrenches
3. 9/16"or Adjustable Wrenches
4. Funnel
DISCONNECTING SPARK PLUG
• Disconnect the spark plug wire and move it
away from the spark plug before assembling the
chipper-shredder. See figure 2.
Spark Plug Wire
IMPORTANT: This unit is shipped without gasoline
or oil in the engine. After assembly, see
OPERATION section of this manual for proper fuel
and engine oil fill-up.
NOTE: To determine right and left hand sides of your
chipper-shredder, stand behind the unit with the
engine farthest away from you.
Your chipper-shredder has been completely assembled
at the factory, except for the hopper assembly, chipper
chute, discharge chute and the catcher bag.
These parts are shipped loose in the carton. A pair of
safety glasses and a bottle of oil are also included In
the carton.
UNPACKING FROM CARTON
• Cut the corners of the carton.
• Remove all packing inserts.
Figure 2
ATTACHING DISCHARGE CHUTE
• Remove the wing knobs from each side of the
discharge opening on the chipper-shredder. See
figure 3.
• Using two 7/16" wrenches, remove hex lock nut,
two spacers, and the hex bolt from top of the
housing assembly. For easy assembly, do not
remove the second spacer from the hex bolt.
• Place the discharge chute in position on the
discharge opening. Insert hex bolt and spacer