Craftsman 315.268260 - Manual (Page 3)

RULES FOR SAFE OPERATION (Continued)
SAFETY RULES FOR WORKLIGHTS
A WARNING: Do not operate worklight or charger
near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may
ignite fumes.
A WARNING: Lens and bulb become hot during
use:
• During or immediately after use, don't lay
worklight flat on lens surface or place lens
area in contact with a plastic or fabric
covered surface.
• Handle worklight with care around any
flammable surface.
• Let worklight cool for several minutes after
use before changing bulb.
• Do not use or permit use of worklight in bed
or sleeping bags. This worklight lens can
melt fabric and a burn injury could result.
IMPORTANT SAFETY RULES FOR BATTERY
TOOLS
■ USE ONLY THE CHARGER RECOMMENDED
FOR USE WITH YOUR WORKLIGHT. Do not
substitute any other charger. Use of another
charger could cause batteries to explode causing
possible serious injury.
■ Your battery tool should be charged in a location
where the temperature is more than 50°F but
less than 100°F.
■ Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with
soap and water, then neutralize with lemon juice
or vinegar. If liquid gets in your eyes, flush them
with clean water for at least 10 minutes, then
seek immediate medical attention.
A WARNING: Batteries vent hydrogen gas and
can explode in the presence of a source of
ignition, such as a pilot light. To reduce the risk
of serious personal injury, never use any
cordless product in the presence of open flame.
An exploded battery can propel debris and
chemicals. If exposed, flush with water immedi­
ately.
A WARNING: Never use a battery pack that has
been damaged or received a sharp blow. A
damaged battery pack is subject to explosion.
Properly dispose of a damaged battery pack
immediately. Failure to heed this warning can
result in serious personal injury.
■ WHEN SERVICING USE ONLY IDENTICAL
CRAFTSMAN REPLACEMENT PARTS.
IMPORTANT SAFETY
INSTRUCTIONS FOR CHARGER
■ Before using battery charger, read all
instructions and cautionary markings in this
manual, on battery charger, and product using
battery charger.
j A CAUTION: To reduce the risk of injury, charge
only nickel-cadmium type rechargeable batteries.
Other types of batteries may burst causing
personal injury and damage.
■ Do not expose to wet or damp conditions.
I To reduce the risk of damage to charger body
and cord, pull by charger plug rather than cord
when disconnecting charger.
■ ‘ An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric
shock. If extension cord must be used, make
sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b. That extension cord is properly wired and in
good electrical condition; and
c. That wire size is large enough for AC ampere
rating of charger as specified below:
Cord Length (Feet) 25’ 50' 100'
Cord Size (AWG) 16 16 16
Note: AWG = American Wire Gage
■ DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged, have
replaced immediately by a qualified serviceman.
■ Do not operate charger if it has received a sharp
blow, been dropped, or othenwise damaged in
any way; take it to a qualified serviceman.
■ Do not disassemble charger; take it to a qualified
serviceman when service or repair is required.
Incorrect reassembly may result in a risk of
electric shock or fire.
■ To reduce the risk of electric shock, unplug
charger from outlet before attempting any
maintenance or cleaning. Turning off controls will
not reduce this risk.
■ Do not use charger in wet or damp conditions.
■ Disconnect charger from power supply when not in
use.
■ SAVE THESE INSTRUCTIONS. Review them
frequently and use them to instruct others who
may use this light. If you loan someone this light,
loan them these instructions also.
SAVE THESE INSTRUCTIONS