Craftsman 315.268260 - Manual (Page 5)

OPERATION
A WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
TO ATTACH BATTERY PACK TO WORKLIGHT
See Figure 2.
Note: Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to
"CHARGING BATTERY PACK" for charging instruc­
tions.
■ Align raised ribs on battery pack with grooves on
bottom of worklight, then attach battery pack to
worklight as shown in Figure 2.
■ Make sure latch on battery pack snaps into place
and battery pack is secured to worklight before
turning worklight on.
CAUTION: When attaching battery pack to your
worklight, be sure raised ribs and grooves align
properly and latch snaps into place properly.
Improper assembly can cause damage to
worklight and battery pack.
TO REMOVE BATTERY PACK FROM
WORKLIGHT
See Figure 3.
■ Depress latch located on front of battery pack (1)
to release battery pack.
■ Pull forward on battery pack (2) to remove from
worklight.
LATCH BATTERY PACK Fig. 2