Craftsman 113.179255 - Manual (Page 11)

Accessories (continued)
Hoses (14’ & 7’ Pos-I-Lock)
The Pos-I-Lock Hose has an adapter that
can be used to connect the hose to the
female port on the vac or to the male end
of another hose.
Diffuser Cap Assembly
Attach the lanyard to the vac motor
assembly of the vac to keep the diffuser
attached to vac when using the blower
port. Both the 7' and 14’ hose can be
used independently. They can also be
connected together by first connecting
the single locking hose to the wetfdry vac
(14’ hose from factory). Next, you will
connect the double locking hose (7' from
factory) to the fist hose by inserting the
friction end of the first hose into the larger
locking end of the second hose. This wiil
be a friction connection
Operation
WARNING
To reduce the risk of fire or explosion, do not operate this vac in areas with flam­
mable gases, vapors or explosive dust in the air. Flammable gases or vapors
include but are not limited to; lighter fluid, solvent type cleaners, oil-base paints,
gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to;
coal, magnesium, grain or gun powder. Do not vacuum explosive dust, flammable
or combustible liquids or hot ashes. Do not use this vac as a sprayer. To reduce
the risk of health hazards from vapors or dusts, do not vacuum toxic materials.
CAUTION: To reduce risk of hearing
damage, wear ear protectors when
using the vac for extended hours or
when using it in a noisy area. The
operation of any utility vac can result in
foreign objects being blown into the
eyes, which can result in severe eye
damage. Always wear safety goggies
complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before commenc­
ing operation. Safety Goggles are
available at many local retail stores.
Q
= OFF I = ON
11
To reduce the risk of electric shock, this
appliance has a polarized plug (one
blade is wider than the other). This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "I".
The symbols used on the switch actuator
are international “On & Off" symbols. ’’0''
is the symbol for ’’OFF” and "I" is the
symbol for "ON".