Craftsman 172.27673 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
WARNING.
Your sandor should NEVER be connected to the power source
when you are assembling parts, making adjustments, installing or removing
sandpaper, cleaning or when it is not in use. Disconnecting the sender will prevent
accidental starting, that could cause serious personal injury.
INSTALLING THE SANDPAPER (See Fig. 3)
ALWAYS inspect the sandpaper before installing. DO NOT use if broken or defective.
1. Unplug the sender.
zìi WARNING:
Failure to unplug the sander could result in accidental
starting causing possible serious personai injury.
NOTE: Remove cyclonic dust box assembly when installing sandpaper. ALWAYS
remember to reattach the cyclonic dust box assembly before beginning sanding
operation (see page 14, Fig. 4).
2. Align the holes in the sanding disc with the holes in the hook and loop backing pad.
NOTE: Holes in sanding disc must line up with holes in the backing pad in order for
the dust collection feature of the sander to function properly.
3. Press the sanding disc against the backing pad as firmly as possible.
NOTE: For best adhesion, we recommend that you clean the backing pad and the
sanding disc backing occasionally by brushing them lightly with a small brush.
Fig3
Sander
5-in.
Hook and Loop
Backing Pad
>5-in. Hook and Loop
Sanding Disc with
Pre-Punched holes
13