Operation – Craftsman 315.114073 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

Mm

WARNING: Do not allow familiarity with worklights

to make you careless. Remember that a careless

fraction of a second is sufficient to inflict serious

injury.

WARNING: Do not use any attachments or acces­

sories not recommended by the manufacturer of this
worklight. The use of attachments or accessories not

recommended can result in serious personal injury.

CAUTION:

if at any point during the charging

process none of the LEDs are lit, remove the bat­

tery pack from the charger to avoid damaging the

product. DO NOT insert another battery. Return the
charger and battery to your nearest service center
for service or replacement.

LED FUNCTIONS OF CHARGER

LED WILL BE ON TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:

■ Red LED on = Fast charging mode.

■ Green LED on = Fully charged and in maintenance

charge mode.

■ Green LED on = When battery pack is inserted into

charger, indicates hot battery pack or that battery pack

is out of normal temperature range.

■ Yellow and Green LEDs on = Deeply discharged or

defective battery pack.

■ No LED on = Defective charger or battery pack.

CHARGING THE BATTERY PACK

The battery pack for this worklight has been shipped in a

low charge condition to prevent possible problems. There­
fore, you should charge it until the green LED on the front

of the charger comes on.

NOTE:

Batteries will not reach full charge the first time

they are charged. Allow several cycles (operation followed

by recharging) for them to become fully charged.

CHARGING A COOL BATTERY PACK

If battery pack is below normal temperature range, the

green LED on charger will come on. Allow battery pack to

reach normal temperature, then the red LED will come on.

NOTE:

If the charger does not charge the battery pack

under normal circumstances, return both the battery pack
and charger to your nearest Sears Repair Center for
electrical check.

■ Charge the battery pack only with the charger provided.

■ Make sure the power supply is normal household

voltage,

120 volts, 60 Hz, AC only.

■ Connect the charger to the power supply.

■ Place the battery pack in the charger aligning raised rib

on the battery pack with the groove in the charger. See

Figure 2.

■ Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

■ Normally the red LED on charger will come on. This

indicates the charger is in fast charging mode,

■ Red LED should remain on for approximately 1 hour

then the green LED will come on. Green LED on

indicates battery pack is fully charged and charger is
in maintenance charge mode.

NOTE:

The green LED will remain on until the battery

pack is removed from the charger or charger is
disconnected from the power supply.

■ If both yellow and green LEDs come on, this indicates

a deeply discharged or defective battery pack. Allow
the battery pack to remain in the charger for 15 to 30

minutes. When the battery pack reaches normal
voltage range, the red LED should come on. If the red

LED does not come on after 30 minutes, this may
indicate a defective battery pack and should be

replaced.

■ After normal usage, a minimum of 1 hour of charging

time is required to fully recharge battery pack.

■ The battery pack will become slightly warm to the

touch while charging. This is normal and does not

indicate a problem,

■ Do not place the charger and battery pack in an area

of extreme heat or cold. They will work best at normal

room temperature.

NOTE:

The charger and battery pack should be placed

in a location where the temperature is more than 50°F

but less than 100“F.

■ When batteries become fully charged, unplug the

charger from power supply and remove the battery

pack.

BATTERY PACK

SHOWN IN CHARGER

10

Advertising