Ideal set up, For siphon feed connection, Before using spray gun – Craftsman 919.155190 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
fWiPORTANT: The use Of a oil/wafer extractor is recommenOed. See set
illustrations for exampies.
Basic Set Up
. To Air Supply- ^
air compressor
ec|uipped with a
regulator
Ideal Set Up
To air supply -
hard plumbed
air supply
ACAUTION
Before Using Spray Gun
This gun is designed
for use with most
finishing materials- It is not
designed for use with corrosive or
highly abrasive materials. Using
these materials can lead to poor
performance and/or failure of this
product.
1, Mix materiai according the
manufacturer’s instructions.
Mixture should be smooth and
easily pourable. Lumps or foreign
particles should be removed by
straining through a suitable paint
filter, NOTE: Using a Sears
Viscosimeter will help In
measuring the viscosity or
thickness of the materiai.
For Siphon Feed Connection
1. Remove the material cup from
fid/gun assembly. NOTE: Slide
release lever to the right, rotate
fid, and remove materiai cup.
2,
Fill the material cup 3/4 full.
3, Attach materiai cup to the lid/gun
assembly and slide release iever
to the left to secure in place,
NOTE: When replacing lid/gun
assembly make sure bend in material
tube is positioned to the front of the
spray gun as shown.
4.
5,
Attach air supply line to 1/4 NPT
air inlet.
See "Operation" Section to learn
how to use the spray gun.
029783
6- ENG
D29783