Craftsman 919.155190 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Convert to Remote Pressure
Feed
If the material to be sprayed is too
heavy for siphon feed or higher
volume application is desired, convert
to the pressure feed set up.
1.
2
.
Remove the material cup from
fid/gun assembly. NOTE: Slide
release lever to the right, rotate
fid, and remove material cup.
Slide yoke, with built in socket
feature, over nut. Grip the yoke
and turn to loosen nut, after the
nut is loosened hand turn until lid
assembly can be removed from
gun.
3. The gun is now ready to be
connected to any pressure teed
tank with a standard 3/8" straight
pipe female connection. See
paint tank manufacturer's manual
for correct procedure,
4, See "Operation" Section to learn
how to use the spray gun,
NOTE: When replacing lid assembly to
gun assembly hand tighten nut and
then slide yoke over nut to tighten
securely.
Typical Pressure Feed Set Up
7- ENG
D297S3