Craftsman 919.155190 - Manual (Page 8)

OPERATION
Know Your Spray Gun
Machined Brass
Externa! Mix CaP'
Air Cap Horns
Fluid Needle Adjustment Nut
Pattern Control
nob
Fluid Control
Knob
Hardened Steel
Fluid Tip
Release Lever
1 - Quart
Siphon Feed
Material Cup
1/4" NPT Air Inlet
Air Valve
Control Knob
Machined Brass External Mix Cap -
The air and matersai are mixed after
¡eaving the nozzle to provide a
superior finish with thick and thin
matetial.
Hardened Steel Fluid Tip - for long
fife.
Air Cap Horns - determines a
horizontal or vertical spray pattern.
Fluid Con&ol Knob - controls the
fluid or density of fan spray.
Pattern Control Knob - controls the
size of the pattern from a large oblong
to small round pattern.
Air Valve Control Knob - fine tunes
the material spray with air.
1 / 4 « isjp-f Inlet- allows the spray
gun to be connected to the air supply.
Release Lever - releases lid/gun
assembly from material cup.
Yoke - with built in wrench used to
easily remove gun from material cup
without tools.
ACAUTION
I Before
I disassembly or re­
moval of any part of gun or attached
components, shut off compressor,
release pressure by depressing
trigger, and disconnect power
source. NEVER assume system
pressure is zero!
ACAUTION
Prior to daily
operation, make
certain that all connections and fit­
tings are secure. Check hose and all
connections for a weak or worn
condition that could render system
unsafe. All replacement components
such as hose or fittings must have a
working pressure equal to or greater
than system pressure.
TO AVOID CREATING
AN EXPLOSIVE
ATMOSPHERE, WORK ONLYfN
WELL VENTILATED AREAS.
AWARNING
029783 8- ENG