Storage, Tractor, Battery – Craftsman YS 4500 917.28990 User Manual

Page 29: Engine oil, Other

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

Immediately prepare your tractor for stor­

age at the end of the season or if the trac­

tor will not be used for 30 days or more.

^WARNING: Never store the tractor

with gasoline in the tank inside a building
where fumes may reach an open flame

or spark. Allow the engine to cool before

storing in any enclosure.

TRACTOR

When tractor is to be stored for a period

of time, clean it thoroughly, remove all dirt,
grease, leaves, etc. Store in a clean, dry

area.

1. Clean entire tractor (See “CLEANING”

in the Maintenance section of this

manual).

2. Inspect and replace belts, if necessary

(See belt replacement instructions in

the Service and Adjustments section of
this manual).

3. Lubricate as shown in the Maintenance

section of this manual.

4. Be sure that all nuts, bolts and screws

are securely fastened. Inspect moving

parts for damage, breakage and wear.

Replace if necessary.

5. Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

BATTERY

• Fully charge the battery for storage.
• After a period of time in storage, battery

may require recharging.

• To help prevent corrosion and power

leakage during long periods of storage,

battery cables should be disconnected

and battery cleaned thoroughly (see
“TO CLEAN BATTERY AND TERMI­

NALS” in the Maintenance section of

this manual).

• After cleaning, leave cables disconnect­

ed and place cables where they cannot
come in contact with battery terminals.

• If battery is removed from tractor for

storage, do not store battery directly on

concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent
gum deposits from forming in essential

fuel system parts such as carburetor, fuel

hose, or tank during storage. Also, alcohol

blended fuels (called gasohol or using
ethanol or methanol) can attract moisture

which leads to separation and formation of
acids during storage. Acidic gas can dam­
age the fuel system of an engine while in
storage.

• Empty the fuel tank by starting the en­

gine and letting it run until the fuel lines

and carburetor are empty.

• Never use engine or carburetor cleaner

products in the fuel tank or permanent
damage may occur.

• Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable

alternative in minimizing the formation of

fuel gum deposits during storage. Add

stabilizer to gasoline in fuel tank or stor­
age container. Always follow the mix ratio

found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer

to allow the stabilizer to reach the car­

buretor. Do not empty the gas tank and
carburetor if using fuel stabilizer.

ENGINE OIL
Drain oil (with engine warm) and replace

with clean engine oil. (See “ENGINE” in

the Maintenance section of this manual).

CYUNDER(S)

1. Remove spark plug(s).

2. Pour one ounce of oil through spark

plug hole(s) into cylinder(s).

3. Turn ignition key to start position for a

few seconds to distribute oil.

4. Replace with new spark plug(s).

OTHER

• Do not store gasoline from one season

to another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your

gasoline will cause problems.

• If possible, store your tractor indoors

and cover it to give protection from dust
and dirt.

• Cover your tractor with a suitable

protective cover that does not retain
moisture. Do not use plastic. Plastic
cannot breathe which allows condensa­

tion to form and will cause your tractor
to rust.

IMPORTANT: Never cover tractor while
engine and exhaust areas are still warm.

29

Advertising
This manual is related to the following products: