Safety instructions coni – Craftsman 320.17541 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SAFETY INSTRUCTIONS coni.

TOOL USE AND CARE SAFETY

A WARNING:

BE SURE to read and understand all instructions before

operating this router. Failure to follow all instructions listed below may result
in electric shock, fire and/or serious personal injury.

2

.

1. ALWAYS use clamps or other practical ways to secure and support the workpiece

to a stable platform.

Holding the work by hand or against your body is unstable and

may lead to loss of control.

DO NOT force the tool. Use the correct tool and bit for your application.

The correct

too! and bit will do the job better and safer at the rate for which it is designed.

DO NOT use the tool

if

switch does not turn it “On” or “Off”.

Any tool that cannot be

controlled with the switch is dangerous and must be repaired.

DISCONNECT the plug from the power source before making any adjustments,
changing accessories or storing the tool.

Such preventive safety measures reduce

the risk of starting the tool accidentally-

NEVER leave the tool running. ALWAYS turn it off. DO NOT

leave the tool until it

comes to a complete stop,

STORE Idle tools out of the reach of children and other untrained persons.

Tools

are dangerous in the hands of untrained users.

MAINTAIN tools with care. Keep cutting tools sharp and clean.

Properly maintained

tools with sharp cutting edges are less likely to bind and are easier to control.

CHECK for misalignment or binding of moving parts, breakage of parts,

and any

other condition that may affect the tool's operation. If damaged, have the tool serviced
before using. Many accidents are caused by poorly maintained tools.

USE ONLY accessories that are recommended for this tool.

Accessories that may be

suitable for one tool may become hazardous when used on another tool.

ELECTRICAL SAFETY

A WARNING:

Do

not permit fingers to touch the terminals of plug when

instaliing or removing the plug from the outlet.

1 Doubie insulated tools are equipped with a polarized plug (one blade is wider

than the other).This plug will fit in a polarized outlet only one way.

If the plug

does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a

qualified

electrician

to install a polarized outlet Do not change the plug in any way.

2. Doubie insulation B eliminates the need for the three-wire grounded power

cord and grounded power supply system. Applicable only to Class !l (double-insulated)
tools.

This router motor is double insulated.

^

WARNING:

Double insulation DOES NOT take the place of normal safety

precautions when operating this tool.

Advertising