Craftsman 320.17541 - Manual (Page 7)

SAFETY INSTRUCTIONS cont.
iSIEFliN^I Cwf IE f
1. tf any part of this router is missing or should break, bend, or fail In any way;
or should any electrical component fall to perform properly: SHUT OFF
the power switch and remove the router plug from the power source and have the
missing, damaged or faiied parts repiaced
BEFORE resuming operation,
2. Tool service must be performed only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could resuit in a
risk of injury,
3. When servicing a tool, use only identical replacement parts. Follow instructions
in the maintenance section of this manual. Use of unauthorized parts or failure to
follow maintenance instructions may create a risk of electric shock or Injury.
SAFETY RULES FOR ROUTERS
A
CAUTION: Cutter bits coast after router is switched off.
4,
5.
1. HOLD TOOL by insulated gripping surfaces (handles) when performing an
operation where the cutting tool may contact hidden wiring or its own cord.
Contact with a "live” wire wili make the exposed metal parts of the tool “live" and
shock the operator,
2. Maintain a firm grip on the router with both hands to resist starting torque.
3. NEVER attempt to use the router motor without first installing It in an approved
fixed base. Failure to heed this warning could result in personal injury and
damage to the motor.
MAKE SURE the motor housing does not move up or down when damped in the
fixed base. If motor is not securely clamped in base, adfustments will
not be accurate.
DO NOT HAND-HOLD THE ROUTER IN AN UPSIDE DOWN OR HORIZONTAL
POSITION. The motor can separate from the base if not properly attached according
to the instructions,
6. TIGHTEN COLLET / NUT securely to prevent the cutter bit from slipping. If the
collet/nut is not securely tightened, the cutter bit may detach during use, causing serious
personal injury.
7. NEVER tighten coliet/nut without a cutter bit installed in the collet/nut.
8 . USE CLAMPS or other practicai ways to secure and support the workpiece to
a stable platform and hold the workpiece rigidly in position. Holding the work by
hand or against your body is unstable and may lead to loss of control,
9. NEVER hold the piece being cut in your hands or across your legs. It is important
to support and clamp the workpiece properly in order to minimize body exposure,
bit binding, or loss of control.
10. ALWAYS keep chip shield clean and in place.
11. STAY ALERT and clear the Router cutter bit path of any obstructions BEFORE
starting the motor. Keep cutting area clear of all foreign objects while motor is
running.
12. CHECK TO SEE that the cord will not “hang up” during routing operation.