How to use your snow thrower, Stopping, To use throttle control (see fig. 11) – Craftsman 944.528398 User Manual

Page 11: To control snow discharge (see fig. 13), To use choke control (see fig. 12), To throw snow (see fig. 14), Operation

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

The operation of any snow thrower can result

in foreign objects thrown into the eyes, which
can result in severe eye damage. Always wear

safety glasses or eye shields while operating
your snow thrower or performing any adjust­

ments or repairs. We recommend standard safety glasses
or a wide vision safety mask worn over spectacles,

HOW TO USE YOUR SNOW THROWER

Know how to operate all controls before adding fuel or
attempting to start the engine,

STOPPING

TRACTION DRIVE

Release traction drive control lever to stop the forward

or reverse movement of the snow thrower,

AUGER

Release the auger control lever to stop throwing snow,

ENGINE

1, Move ON / OFF switch to “OFF” position,

2, Remove (do not turn) safety ignition key to prevent

unauthorized use,

NOTE: Never use choke to stop engine,

TO USE THROTTLE CONTROL (See Fig. 11)

The throttle control is located on the engine. Always operate
the snow thrower with the engine at full throttle. Full throttle

offers the best snow thrower performance.

TO CONTROL SNOW DISCHARGE (See Fig. 13)

FIG. 11

TO USE CHOKE CONTROL (See Fig. 12)

The choke control is located on the engine. Use the choke

control whenever you are starting a cold engine. Do not
use to start a warm engine,

• To engage choke, turn knob clockwise. Slowly turn

knob counterclockwise to disengage.

A

A

WARNING: Snow throwers have ex­

posed rotating parts, which can cause

severe injury from contact, or from ma­
terial thrown from the discharge chute.

Keep the area of operation clear of all
persons, small children and pets at all

times Including startup.

WARNING: If the discharge chute or
auger become clogged, shut-off engine
and wait for all moving parts to stop. Use
the clean-out tool, NOT YOUR HANDS,
to unclog the chute and/or auger.

The DIRECTION in which snow is to bethrown is controiied

by the discharge chute controi iever,

To change the discharge chute position, press down­

ward on discharge chute controi iever and move iever

ieft or right untii chute is in desired position. Be sure
iever springs back and iocks into desired position.

The DISTANCE that snow is thrown is controiied by the

position of the chute defiector. Set the defiector iow to

throw snow a short distance; set the defiector higher to
throw snow farther,

Press downward on chute defiector controi iever and

move ieverforward to iowerthe defiector and decrease

the distance. Move iever back to raise the defiector
and increase the distance. Be sure iever springs back
and iocks into desired position.

TO THROW SNOW (See Fig. 14)

The auger rotation is controiied by the auger controi iever

iocated on the right side handle,

• Squeeze auger control lever to handle to engage the

auger and throw snow.

Release the auger control lever to stop throwing snow.

11

Advertising