Craftsman 919.763500 - Manual (Page 12)

Check and Clean inlet Screen: Examine iniet screen
on pump inlet fitting. Clean if clogged replace if torn.
Check High Pressure Hose: High pressure hose can
develop leaks from wear, kinking, abuse. Inspect hose
each time before use. Check for cuts, teaks, abrasions
or bulging of cover, damage or movement of couplings.
If any of these conditions exist, replace hose
immediately.
Check Chemical/Soap Hose: Examine the chemical/
soap hose and clean if clogged. Hose should fit tightly
on pump fitting. Check for leaks and tears. Replace
filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection to
gun making sure it is secure. Test trigger by pressing it
and making sure it springs back into place when you
release it.
Pressure Washer Maintenance
Pump Oil
Pump oil level should be checked before each use.
Changing Pump Oil
Oil should be changed after the first 10 hours of opera­
tion. Subsequent changes after each 50 hours of opera­
tion. To drain oil, simply remove oil plug with a adjust­
able wrench. The oil plug is located at the bottom of the
pump. Dispose of used oil. Properly remove pump oil fill
plug. Add 30 weight non-detergent oil. Fill until oil level Is
at the mid point on the sight glass.
Purge Pump of Air and Contaminants
To remove the air from the pump, follow these steps:
• Set up the pressure washer as described in
Assembly section and connect the water supply,
• Remove the wand extension from the spray gun.
• Pull the trigger on the gun and hold.
To remove the contaminants from the pump, follow
these steps:
• Set up the pressure washer as described in
ASSEMBLY section, connect the water supply.
• Remove the wand extension from the spray gun.
• Start the engine according to instructions in the
OPERATION section.
When the water supply is steady and constant,
disengage trigger and refasten the wand extension.
Pul! the trigger on the gun and hold.
Engine Maintenance
OH
• Oil level should be checked prior to each use
or at least every 5 houf^ of operation. To check oil see
Adding Engine OH on page 9.
Changing Engine Oil
For 3 new engine, change oil after the first 5 hours of
operation. Thereafter, change oii after every 100 hours of
operation.
Change the oil while the engine is still warm. The oil wilt
flow freely and carry away more impurities. Make sure
the engine is level when filling, checking, or changing oil.
Change the oil as follows:
• To keep dirt, grass clippings, etc., out of the engine,
clean the area around the drain plug and dipstick
before removing it.
• Remove the oil drain plug and dipstick. Be sure to
allow ample time for complete drainage.
PLUG
Reinstall the drain plug. Make sure it is tightened
securely.
Fill the crankcase with new oil of the proper type, to
the Full mark on the dipstick. Always check the level
with the dipstick before adding more oil.
F
1
Operating
Range tm
! ........
L
T” Mark
12