Craftsman 919.679240 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
On the end of your spray gun is a nozzle that you can
slide forward and backward and that you can also
■ist from side to side. With the adjustable nozzle you
1
adjust the spray pattern to either high pressure
or low pressure. You can also adjust the spray so it is
concentrated in a stream pattern or expanded into a
fan pattern.
How To Use Your Pressure Washer
Slide the nozzle in aforward position to draw
cherfiical and achieve low pressure. Pull nozzle back
for high pressure.
IMPORTANT; Use soaps and chemicals that are
designed specifically for use with pressure washers.
To apply soaps/chemicals follow these steps:
• Prepare the soap/chemical as required by your job.
• Insert soap/chemical line into your container (soap/
chemicals and container not included).
Using Soaps/Chemicals
CHEMICAL
HOSE
HIGH PRESSURE
LOW PRESSURE
To adjust your spray pattern twist the nozzle
clockwise for fan spray or counterclockwise for
stream: spray.
FAN SPRAY
STREAM SPRAY
For most effective cleaning, keep spray nozzle
between 8 and 24 inches from cleaning surface.
IMPORTANT: If you get spray nozzle too close,
especially on high pressure, you may damage the
surface you are cleaning.
•
• The pressure control knob is located on the pump.
You can increase the pressure by turning the knob
clockwise or decrease the pressure by turning the
knob counterclockwise.
Slide the adjustable nozzle forward to low pressure
mode. Soap/chemicals cannot be applied with nozzle
in high pressure position.
Review the use of the adjustable nozzle.
Connect garden hose to water inlet (see “To Start
Your Pressure Washer" on page 9). Check that high
pressure hose is connected to spray gun and pump
{see Assembly), and start engine.
Apply soap/chemicals to dry surface, starting from
the bottom and working up.
Allow the soap/chemicals to soak in between 3-5
minutes before washing and rinsing.
When rinsing on high pressure, start at lower portion
of area to be washed and work upward, using long,
even, overlapping strokes.
NOTE: Your pressure washer is equipped with a
chemical injector adjustment knob. With the knob
fully opened you will get a maximum chemical draw.
With knob fully closed you will get no chemical draw.
Turn knob in counterclockwise direction to achieve
more chemical draw and clockwise for less chemical
draw.
NOTE: This unit is set at its maximum pressure at the
tory. Do not attempt to adjust the pressure higher
L, lan this factory setting.
10