Fluorescent tube replacement, Maintenance, Fiq. 5 – Craftsman 315.114071 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

WARNING:

When servicing, use only identical

' Craftsman replacement parts. Use of any cither part

may create a hazard or cause product damage.

WARNING:

Do not at anytime let brake fluids,

‘ gasoline, petroleum-based products, penetrating oils,

etc. come in contact with plastic parts. They contain

chemicals that can damage, weaken or destroy

plastic.

Do not

abuse power tools. Abusive practices can damage

tool as well as workpiece.

WARNING

: Do not attempt to modify this

worklight

or

create accessories not recommended for use with

this worklight. Any such alteration or

rrrodificatiQn

is

misuse and could result in a hazardous condition

leading to possible serious personal injury.

FLUORESCENT TUBE REPLACEMENT

See

Figure 4.

When purchasing replacement fluorescent tube, request

recommended part number 7819602. See

Figure 5.

TO REPLACE FLUORESCENT TUBE;

■ Remove battery pack from worklight. See Page

8.

■ Remove screw to release lens cover. Remove lens

cover by pulling forarard and lifting from tfw housing.

■ To remove old fluorescent tube from spring, gently

grasp the lower edge of the rubber cushion and sides

of bulb. Carefully work tube in a side-to-side motion
while easing tube fonward and up until tube Is free from

the spring. Do not pull fluorescent tube straight out

from its center, as this Increases chance of breakage.

Remove rubber cushion from old fluorescent tube and
place on top of new tube, rounded edge facing

outward.

Insert new fluorescent tube In spring by aligning prongs

on tube with holes In tube socket area. Gently push
down on base of new tube until fully engaged. Do not

force tube into place.

Replace lens cover by sliding lower edge into housing.

Align screw holes at top, With a hand tool, tighten

screw. Do not use drill included In kit to tighten screw,

as drill torque may damage lens cover.

Replace battery pack.

PULL LENS COVER

FORWARD TO REMOVE

SCREW

RUBBER

CUSHION

LENS COVER

FLUORESCENT TUBE

BULB

SOCKET AREA

Fiq. 5

Advertising