Caution: make sure the opening of the bag is, Chip bag assembly - lower filtration housing, Upper filter/dust bag assembly – Craftsman 113.299780 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHIP BAG ASSEMBLY -
LOWER FiLTRATION HOUSING
1. Insert lower
Chip Bag
by tilting the
Metal Reinforced
Band at
an angle and position it through the hole in the
lower
Filtration Housing.
2. Tuck one side of the
Band
under the
Sawdust
Chute Extension.
3.
Allow the opposite side to rest on the ridge of the
opening.
4. Tug on the
Chip Bag
to insure proper seating.
FILTBATION HOUSING
SAWOUST CHUTE
extension
UPPER FILTER/DUST BAG ASSEMBLY
1. Disconnect the
Adjustable
ßandC/ampandinsertthe
end through the loops provided at the opening of the
Fllter/Dust
Sag.
2. Invert the
Filter/Dust Bag and
slip the open end of the
Bag
over the 1" Relief on the top opening of the
Filtration Housing.
3. Secure the
B^
by adjusting the rectangular barto the
fourth set of hooks.
4. Pull the lever tight until it seats itself.
CAUTION: Make sure the opening of the bag Is
tight against the relief so dust will not escape.
FILTER/
DUST BAG
HOLDER
HANDLE
R ELIEF
11