Save these instructions, Assembly – Craftsman 358.799430 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

When using the vacuum attachment,
the unit is designed to pick up dry ma­
terial such as leaves, grass, small
twigs, and bits of paper. Do not vacu­

um stones, gravel, metal, broken
glass, etc., to avoid severe damage to

the impeller. To avoid the possibility of

electrical shock, do not attempt to vac­
uum water or other liquids.

Never run the unit without the proper

equipment attached. When used as a

vacuum, always install vacuum tubes

and collection bag assembly. Make
sure the collection bag assembly is
completely zipped when unit is running

to avoid flying debris. Use only recom­

mended attachments.

Avoid situations which could set the

collection bag on fire. Do not vacuum
discarded matches, cigars, cigarettes,
or ash from fireplaces, barbecue pits,
brush piles, etc. To avoid spreading

fire, do not use blower near leaf or

brush fires, fireplaces, barbecue pits,
ashtrays, etc.

• Always use the collection bag shoul­

der strap when vacuuming to avoid

loss of control.

• Check air intake openings, elbow tube,

and vacuum tubes frequently, always

with the unit stopped and the power

source disconnected. Keep vents and

tubes free of debris which can accu­

mulate and restrict proper air flow. Do
not use with any opening blocked.
Keep free of dust, lint, hair and any­

thing that may reduce air flow.

STANDARDS

This product is listed by Underwriters

Laboratories, Inc., in accordance with
UL Standard 1017.
If situations occur which are not covered
in this manual, use care and good judg­
ment. If you need assistance, contact

your Sears Service Center or call

f -800-235-5878. Failure to follow all
Safety Rules and Precautions can result
in serious injury.

SAVE THESE INSTRUCTIONS

ASSEMBLY

CARTON CONTENTS
Model 358.799430
• Blower
• Blower Tube/Nozzle
• 2 Vacuum Tubes
• Collection Bag

Examine parts for damage. Do not use

damaged parts.

NOTE: If you need assistance or find

parts missing or damaged, call

1-800-235-5878.

A WARNING;

Stop the unit and

disconnect from the power source be­
fore opening the inlet cover or attempt­
ing to insert or remove the inlet restrictor,
blower tube/nozzle, or vacuum tubes.
The motor must be stopped and the im­
peller blades no longer turning to avoid
serious injury from the rotating blades.

A WARNING;

If received as­

sembled, ensure your unit is properly
assembled and all fasteners are secure.

BLOWER ASSEMBLY
NOTE: Assembly instructions for using
your unit as a vacuum follow this sec­

tion.

ATTACHING THE BLOWER TUBE/

NOZZLE
If you have already assembled your
unit for use as a vacuum, remove the

vacuum tubes and the collection bag.

1

2

.

Insert the blower tube/nozzle into

the blower outlet.
Twist the blower tube/nozzle

clockwise until it is firmly seated in

the blower outlet. Make sure the

nozzle end points upward as shown
in the following illustration.

Blower Tube/Nozzle

VACUUM ASSEMBLY

NOTE: Assembly instructions for using

your unit as a blower are explained in
the previous section.

If you have already assembled your
unit for use as a blower, remove the
blower tube/nozzle.

Advertising