Adjustments, 0/ ring – Craftsman 315.269210 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ADJUSTMENTS

ADJUSTING DEPTH OF CUT

See Figures 3, 4, 5, and 6.

We recommend that cuts be made at a depth not

exceeding 1/8 in. and that several passes be made to
reach depths of cut greater than 1/8 in.

■ Unplug your router.

A WARNING: Failure to unplug your router could

■*“ result in accidental starting causing serious

injury.

■ Place router on a flat surface and loosen locking

arm.

See Figure 3.

LOCKING

ARM

Fig.3

Turn depth adjusting ring until cutter is inside
subbase.

See Figure 4.

Turn depth adjusting ring until tip of cutter touches
flat surface.

TO

LOWER

CUTTER

TO RAISE

CUTTER

INDICATOR

POINT

CUTTER

INSIDE SUBBASE

DEPTH

, ADJUSTING

0/ RING

DEPTH

INDICATOR

RING

Turn the depth indicator ring until the zero lines up
with the indicator point on the base.

See Figure 5.

DEPTH OF CUT

Fig. 5

Position router so that the cutter can extend below

the subbase for desired depth setting.

See

Figure 6.

BELOW SUBBASE

Fig. 6

SUBBASE

Fig. 4

Turn the depth adjusting ring to obtain the desired
depth of cut. The distance the cutter moves can be

read on the depth adjusting ring. Each mark on the

depth adjusting ring indicates 1/32 inch change in
depth setting. Indicator point is located on the

base.

Tighten locking arm securely.

10

Advertising