Craftsman 536881851 - Manual (Page 10)

ASSEMBLY
^ CHECKLIST
Before you operate your new snow
thrower, to ensure that you receive the
best performance and satisfaction from
this quality product, please review the
following checklist;
All assembly instructions have been
completed.
The discharge chute rotates freely.
No remaining loose parts in carton.
Check the fasteners. Make sure all
fasteners are tight.
Check the air pressure of the tires.
Correct air pressure is from 14 to 17
PSI. See the side of the tire for maxi­
mum inflation. Do not exceed maxi­
mum inflation.
On electric start models, the unit was
shipped with the starter cord plugged
into the engine. Before operating, un­
plug the starter cord from the engine.
While learning how to use your snow
thrower, pay extra attention to the fol­
lowing important items:
Engine oil is at proper level. Use a
high quality detergent oil classified
“For Service SG, SH, SJ, SL, or
higher”.
^ Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline
with a minimum of 85 octane.
^ Become familiar with all controls-
their location and function. Operate
controls before starting engine.
10