How to remove the snow hood, Service and adjustment – Craftsman 536881851 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENT
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 21).
2. Remove the safety key.
3. Remove the mounting screws
(see Figure 22).
4. Slowly remove the snow hood.
Make sure that the primer button
hose and the ignition wire are not
disconnected.
5. The spark plug can now be ac
cessed.
6. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine
and secure with the mounting
screws (see Figure 22).
8. Connect the choke control knob
with the choke shaft on the carbure
tor (see Figure 23 and Figure 24).
Make sure the choke control knob is
properly installed. If the choke con
trol knob is not installed correctly,
the choke will not operate.
9. Install the safety key.
Choke
Control
Mounting Screws
Snow Hood
Spark
Plug
igure 22
Choke
Control Knob
Choke Shaft
Figure 21
Carburetor
Figure 24
22