Secure the throttle cables, Zip tie, Adjusting the handle – Craftsman 316.794800 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY INSTRUCTIONS
The completed blower tube should look like Figure 6.
Secure the Throttle Cables
Place a zip tie around the elbow tube and the throttle cables (Fig.
7) as shown, making sure not to crimp the cables.
u
Zip Tie
Adjusting the Handle
1.
Rotate the throttle grip counterclockwise around the blower
tube until It Is pointing directly downward (Fig. 8, A).
WARNING:
Do not rotate the handle clockwise to
adjust. This may cause the throttle cables to
disconnect from the throttle grip or the engine.
^ B
2
.
3.
Pull or push the throttle grip along the handle tube until Its
distance from the backpack blower Is comfortable (Fig. 8, B).
Align the throttle grip with the slot closest to the comfortable
place and rotate the throttle grip clockwise Into the upright
position (Fig. 9).
A
WARNING:
To avoid serious personal Injury, make
sure that the blower tubes are locked In place or firmly
Installed.