Craftsman 315.117260 - Manual (Page 15)

MAINTENANCE
WARNING: When servicing, use oniy identical
Craftsman replacement parts. Use of any other
part may create a hazard or cause product
damage.
WARNING: The belt sender should never be
connected to a power supply when you are
assembling parts, making adjustments, cleaning,
performing maintenance, or when the tool is not in
use. Disconnecting the tool prevents accidentai
starting that could cause serious injury.
GENERAL
Only the parts shown on the parts list are Intended to be
repaired or replaced by the customer. All other parts are
an important part of the double insulation system and
should be serviced only by a qualified Sears service
technician.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commerciai solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
Electric tools used on fiberglass material, wallboard,
speckling compounds, or piaster are subject to
accelerated wear and possible premature failure
because the fiberglass chips and grindings are highly
abrasive to bearings, brushes, commutators, etc.
Consequently, we do not recommend using this tool for
extended work on these types of materials. However, if
you do work with any of these materials, it is extremely
important to clean the tool using compressed air.
A WARNING: Always wear safety goggles or safety
glasses with side shields during power tool
operation or when blowing dust. If operation is
dusty, also wear a dust mask. Failure to do so
could result in possible serious injury.
LUBRICATION
All the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of
the tool under normal operating conditions. Therefore,
no further lubrication is required.
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating
oils, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken, or
destroy plastic.
15