Step 4 install chain and cable, Step 4, Assembly – Craftsman 139.535006 User Manual
Page 8: Install chain and cable
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
STEP 4
Install Chain and Cable
Master
Link
Clip-On
Spring
Cable
Loop
Flat End
Trolley
Shall
DO
NOT REMOVE CHAIN AND CABLE FROM DIS-^
PENSER CARTON.
Detach cable from side of car ton and fasten to tr olley
with a master link from coin envelope,
MASTER LINK PROCEDURE: Push pins of master
link bar through loop of cable and hole in flat end of
trolley shaft Push cap onto pins and into notches
Slide clip-on spring over cap and into pin notches
until both pins are locked in place.
opener Chassis
Sprocket'
Ivl aster
Link
Outside
Bar
CAUTION: Keep chain taut while dispensing from
carton to help prevent kinking.
Slide trolley tight against screwdriver stop Dispense
cable around pulley bracket. Proceed back around
the opener sprocket and forward to chain retainer
bracket. Be sure teeth on chassis sprocket engage
chain.
Connect chain to chain retainer bracket, as shown in
inset, using second master link from coin envelope,
NOTE: Check to make sure chain is not twisted.