Craftsman 139.53225SRT - Manual (Page 20)

Installation Step 9
Electricai Requirements
To rr;dU‘:o tho nak of oiooirfo ;.;hock, your garago
door opt-fU!f har- a grounding type plug with a third
grounding pin. Tins plug v/ill
only ht into a grounding
type outlei.
!l the plug doesn't fit into the outio! you have,
contac .1 a qualified eiectrictan to instaii the proper
outlet.
To awoid instaUatton difflciilffes,
do nat run the opener
at
this time.
To pmmnt eiectmmtton or fire, Instaliatlon
and wiring must be In c©tnpli.ance with local
electrical and buildlrtg codes.
Oo NOT use an exlenslon cord, 2-wlre adapter.
Of change the plug fn any way ta make: It fit
your outlet
'©
Right Wrong
If permanent wiring is reqoirecf by your local code, refer to the following procedure:
To m.ikr> ,1 pfrnicmf'fU connc-ction through the
7/'8” diameter tioic m ihn top of the opcnei
^according to ïrcat corJcr
• Remove Itio opener urver screws and cet the
cover aside.
• Remove the attached 3-prong cord.
• Connect the black (itne) wire to thé screw on the
brass terminât: tie white (ne-ytral) wire to the
screw on the silver terminal; an:Ci the gfo-und wire
to the green groonti: screw. The opener must be
gmunéeé,
• Reinstall the cover.
To
avoid imtalMtim difficulties,
do no! mn the opener at this time.
20