Craftsman 919.679501 - Manual (Page 19)

Repeat the above steps for the opposite side.
Insert the threaded stud of rubber foot (10)
through the middle hole of the foot bracket (5).
Secure with lock nut (8) and tighten.
Locate the support under the electrical outlet end
of the generator. Position foot bracket (5), with
rubber foot installed, under the support and align
the holes in the foot bracket (5) with the slots in
the support. Place one cap screw (9) through each
slot in the support and the holes in the foot
bracket. Secure with the lock nuts (8) and tighten.
Once completed, the wheel kit is ready for use.
Key
No.
Description PART NO.
1 Wheel (2 used) AC-0014
2 Shoulder Bolt (2 used) CAC-60
3 Lock Nut 3/8"-16 (2 used) SSF-8111-ZN
4 Wheel Bracket (2 used) GS-0561
5 Foot Bracket GS-0562
6 Handle GS-0564
7 Handle Cap (2 used) GS-0565
8 Lock Nut 5/16"-18(9 used) SSF-8150
9 Cap Screw 5/16"-18 x 3/4"
(6 used)
SS-12-CD
10 Isolator Foot GS-0587
11 Cap Screw 5/16-18x1.75"
(2 used)
SSF-999-1
12 Washer (2 used) SS-6506-CD
-ENG