Craftsman 315.212120 - Manual (Page 6)

■ ALWAYS STAY ALERT! Do not allow familiarity
(gained from frequent use of your saw) to cause
a careless mistake.
ALWAYS REMEMBER that
a careless fraction of a second is sufficient to
inflict severe injury.
■ STAY ALERT AND EXERCISE CONTROL
Watch what you are doing and use common
sense.
Do not operate tool when you are tired.
Do not rush.
RULES FOR SAFE OPERATION (Continued)
MAKE SURE THE WORK AREA HAS AMPLE
LIGHTING to see the work and that no obstruc­
tions will interfere with safe operaflon BEFORE
performing any work using your saw.
ALWAYS TURN OFF SAW before disconnecting
it, to avoid accidental starting when re-connect­
ing to power supply.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use to instruct other users. If you
loan someone this tool, loan them these instruc­
tions also.
SAVE THESE INSTRUCTIONS
GLOSSARY OF TERMS FOR WOODWORKING
Arbor
The shaft on which a biade or cutting tool is mounted.
Bevel Cut
A cutting operation made with the blade at emy angle
other than 90’ to the miter table.
Crosscut
A cutting or shaping operation made across the grain
of the workpiece.
Compound Miter Cut
A compound miter cut Is a cut made using a miter
angle arvl a bevel angle at the same time.
Freehand
Performing a cut without using a fence, miter gage,
fixture, work damp, or other proper device to keep the
workpiece from twisting or moving during the cut.
Gum
A sticky, sap based residue from wood products.
Miter Cut
A cutting operation made witti the blade at any angle
other than 90' to ttie fence,
Resin
A sticky, sap base substance ttiat has hardened.
Revolutions Per Minute (RPM)
The number of turns completed by a spinning object
in one minute.
Saw Blade Path
The area over, under, behind, or in front of the blade.
As it applies to the workpiece, that area which will be,
or has been, cut by the blade.
Set
The distance that the tip of the sawbiade tooth is bent
(or set) outward from the face of the blade.
Throw-Back
Throwing of a workpiece in a manner similar to a
kickback. Usually associated with a cause other than
the kerf closing, such as a workpiece not being
against the fence, being dropped into the blade, or
being placed inadvertently in contact wi№ the blade.
Through Sawing
Any cutting operation where the blade extends
completely through the thickness of the workpiece.
Workpiece
The item on which the cutting operation is being done.
The surfaces of a workpiece are commonly referred to
as faces, ends, and edges.
Zero Clearance Throat Plate
A plastic throat plate inserted in the miter table that
allows for blade clearance. When you make your first
cut with your compound miter saw, the saw blade cuts
a slot through the throat plate the exact width of the
blade. This provides for a zero clearance kerf that
minimizes workpiece tear-out.
No Hands Zone
The area between the marked lines on ttie left and
right side of the miter table base. This zone Is
identified by no hands zone Itesels placed inside the
marked lines on the miter table base.