Wall header bracket installation, Ceiling header bracket installation, Installation step 2 – Craftsman 139.53993D User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INSTALLATION STEP 2

Install the Header Bracket

You can attach the header bracket either to the wall
above the garage door, or to the ceiling. Follow the
instructions which will work best for your particular

requirements. Do not install the header bracket over

drywall. If installing into masonry, use concrete
anchors (not provided).

WALL HEADER BRACKET INSTALLATION

• Center the bracket on the vertical centerline with the

bottom edge of the bracket on the horizontal line as
shown (with the arrow pointing toward the ceiling).

• Mark the vertical set of bracket holes. Drill 3/16" pilot

holes and fasten the bracket securely to a structural
support with the hardware provided.

HARDWARE SHOWN ACTUAL SIZE

Wall Mounting Holes

[i>

Lag Screw
5/16"-9x1-5/8"

CEILING HEADER BRACKET INSTALLATION

• Extend the vertical centerline onto the ceiling as shown.

• Center the bracket on the vertical mark, no more than

6" (15 cm) from the wall. Make sure the arrow is

pointing toward the wall. The bracket can be mounted

flush against the ceiling when clearance is minimal.

• Mark the side holes. Drill 3/16" pilot holes and fasten

bracket securely to a structural support with the
hardware provided.

Ceiling Mounting Holes

The nail hole Is for

positioning only. -
You must use lag screws

to mount the header bracket.

- Finished Ceiiing -

1 3

Advertising