Troubleshooting table – Craftsman 358.794760 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING TABLE

A WARNING: Always stop unit and disconnect spark plug before perform­

ing any of the recommended remedies below other than remedies that re­
quire operation of the unit.

TROUBLE

CAUSE

REMEDY

Engine will not

start.

1, Engine flooded.

2, Fuel tank empty.
3, Spark plug not firing.
4, Fuel not reaching

carburetor.

5,

Compression low.

1. See “Starting a Flooded Engine”

in Operation section.

2. Fill tank with correct fuel mixture.
3. Install new spark plug.

4.

Check for dirty fuel filter; replace.

Check for kinked or spilt fuel line;

repair or replace.

5. Contact Sears Service (see back cover).

Engine will not

idle properly.

1. Fuel not reaching

carburetor.

2. Carburetor requires

adjustment.

3.

Crankshaft seals worn.

4. Compression low.

1. Check for dirty fuel filter; replace.

Check for kinked or spilt fuel line;

repair or replace.

2. Contact Sears Service (see back cover).

3. Contact Sears Service (see back cover).
4. Contact Sears Service (see back cover).

Engine will not

accelerate,

lacks power, or

dies under a

load.

1. Air filter dirty.

2. Fuel not reaching

carburetor,

3. Spark plug fouled.

4.

Carburetor requires

adjustment.

5. Carbon build up.

6.

Compression tow.

1. Clean or replace air filter.

2. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;
repair or replace.

3. Clean or replace spark plug

and re-gap.

4. Contact Sears Service (see back cover),

5.

Contact Sears Service (see back cover).

6.

Contact Sears Service (see back cover).

Engine smokes

excessively.

1. Choke partially on.

2. Fuel mixture incorrect.

3. Air filter dirty.
4. Carburetor requires

adjustment.

1. Adjust choke.

2. Empty fuel tank and refill with

correct fuel mixture.

3. Clean or replace air filter.

4.

Contact Sears Service (see back cover).

Engine runs hot.

1. Fuel mixture incorrect.

2. Spark plug incorrect.
3. Carburetor requires

adjustment.

4. Carbon build up.

1.

See “Fueling Engine” in Operation

section.

2. Replace with correct spark plug.
3. Contact Sears Service (see back cover) .

4. Contact Sears Service (see back cover).

-

14

Advertising