Blower assembly blower tube assembly, Vacuum assembly, Vacuum bag assembly – Craftsman 358.794760 User Manual

Page 6: Vacuum tube assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
If you have already assembled your
unit for use as a vacuum, remove the

vacuum tubes and collection bag.

1. Align the rib on the upper blower

tube with the groove in the blower

outlet; slide the tube into place.

NOTE: Knob must be loose enough to
allow blower tube to be inserted in
blower outlet. Loosen knob by turning
counterclockwise.

Secure the tube by turning the
knob clockwise.

Align the slots on the lower blower
tube with the tabs on the upper

blower tube.

4. Slide the lower blower tube onto

the upper blower tube.

5. Turn the lower blower tube clock­

wise until a click is felt to secure
the lower blower tube to the upper

blower tube.

NOTE: When the upper and lower
blower tubes are assembled together
properly, the arrows on both tubes will
be aligned.

6. To remove the tubes, turn the knob

counterclockwise to loosen the

tubes; remove the tubes.

HIGH-SPEED NOZZLE ASSEMBLY

When greater air speed is desired, use
the high-speed nozzle.

1. Align the slots on the nozzle with

the tabs on the lower blower tube.

High-Speed

Nozzle

Lower Blower

Tube

Slot

2. Slide the nozzle onto the lower

blower tube.

3. Turn the nozzle clockwise until a

click is felt to secure the nozzle to

the lower blower tube.

VACUUM ASSEMBLY
VACUUM BAG ASSEMBLY

1

.

2

.

Open the zipper on the vacuum
bag and insert the elbow tube.
Push the small end of the elbow

tube through the small opening in
the bag.

NOTE: Make sure edge of the small
opening is flush against the flared area
oil the elbow tube, and the rib on the
elbow tube is on the bottom.

3. Close the zipper on the bag. Make

sure the zipper is closed completely.

4. Remove blower tubes from engine.

5. Insert the elbow tube into the blow­

er outlet. Make sure elbow tube rib
is aligned with the blower outlet
groove.

6. Turn knob clockwise to secure el­

bow tube.

VACUUM TUBE ASSEMBLY

A WARNING: Stop engine and be

sure the impeller blades have stopped

turning before opening the vacuum inlet

door or attempting to insert or remove

Advertising