Installation step 7, Install the battery, Installation step 8 – Craftsman 139.53918d User Manual

Page 18: Install the lights, Installation step 9, Attach the emergency release rope and handle, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INSTALLATION STEP 7

Install the Battery

Make sure motor unit is unplugged.

• Using a Phillips head screwdriver, remove the battery

cover on the motor unit.

• Partially insert battery into motor unit with terminals

facing out.

• Connect the red {+) and black (-) wires from motor unit

to corresponding terminals on battery.

• Replace battery cover.

INSTALLATION STEP 8

Install the Lights

Press the release tabs on both sides of lens. Gently

rotate lens back and downward until the lens hinge is
in the fully open position. Do not remove the lens.

• Install up to a too watt maximum light bulb in each

socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFR

• Reverse the procedure to close the lens.

• If the bulbs burn out prematurely due to vibration,

replace with a Garage Door Opener bulb.

NOTE: Use only standard light bulbs. The use of short
neck or speciality light bulbs may overheat the endpanel
or light socket.

INSTALLATION STEP 9

Attach the Emergency Release Rope
and Handle

Thread one end of the rope through the hole in the top

of the red handle so “NOTICE” reads right side up
as shown. Secure with an overhand knot at least

1" (2.5 cm) from the end of the rope to prevent
slipping.

• Thread the other end of the rope through the hole in

the release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet (1.83 m)

above the floor. Ensure that the rope and handle clear
the tops of all vehicles to avoid entanglement. Secure
with an overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.

100 Watt (Max) —
Standard Light Bulb

A

WARNING

To prevent possible SERIOUS INJURY or DEATH from a

falling garage door:
• If possible, use emergency release handle to disengage

trolley ONLY when garage door is CLOSED. Weak or

broken springs or unbalanced door could result in an open
door falling rapidly and/or unexpectedly.

• NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

• NEVER use handle to pull door open or closed. If rope knot

becomes untied, you could fall.

Trolley

18

Advertising