Craftsman 315.115930 - Manual (Page 6)

ASSEMBLY
àk
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this product. Any such aiteration or modification is
misuse and couid resuit in a hazardous condition
ieading to possibie serious personai injury.
jUlk.
WARNING: To prevent accidentai starting that
couid cause serious personai injury, aiways remove
the battery pack from the product when assembiing
parts.
REMOVING THE WARNING LABEL
See Figure 2.
The spotiight has an attached paper warning iabei on the
iens. Remove this warning iabei before use as shown in
figure 2 .
Fig. 2
OPERATIO
WARNING: Do not aiiow familiarity with products to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING: The lens gets very hot during use. To
reduce the risk of burns, do not touch hot lens. To
reduce the risk of fire, keep away from combustible
materials while in operation.
iÉÉk WARNING: Always wear safety goggles or safety
glasses with side shields when operating products.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury,
A,
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer
of this product. The use of attachments or
accessories not recommended can result in serious
personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
■ To illuminate any areas requiring additional light
■ To illuminate distant objects
CAUTION: Operate in a well ventilated area. Do
not block vents. Keep them clear to allow proper
ventilation.
This product will accept DieHard® 19.2 V lithium-ion
battery packs and Craftsman 19.2 V nickel-cadmium
battery packs.
For complete charging and battery instructions, refer to
the Operator’s Manual for the battery packs and chargers
listed in the General Safety Rules.
BATTERY PROTECTION FEATURES
DieFlard® 19.2 V lithium-ion battery packs are designed
with features that protect the lithium-ion cells and
maximize battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.