Speed selector rod – Craftsman 536.88123 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Place yoke end of crank rod around uni
versal joint, lining up openings, insert
clevis pin through assembly and secure
with cotter pin. Spread ends of cotter pin
to lock in place. See figure below.
Tighten nut on eye bolt, keeping eye in
line with the rod while tightening №e inside
securely.
Tighten all handle bolts with a 9/16"
wrench.
\
Crank Rod
Cotter pin Assembly
Universal joint
pin
Universa! joint
^Wonm Mounting
ASSEMBLE sVibw
* Remove back carriage bolt, see figure
below.
Carriage-
Bolt
Tilt chute back into operating position.
NOTE: DO NOT cut tie strap located on
chute deflector at this time.
• Push remote chute control lever into
"Chute Deflector Down“ position.
• Cut tie strap on chute deflector as shown
in figure below.
Replace carriage bolt.
Tighten carriage bolt securely. NOTE:
Check all bolts in chute ring for tightness.
Remove and discard packaging used to
protect chute.
SPEED SELECTOR ROD
• Cut plastic tie securing shifter lever
assembly to the shifter bracket. See
figure below.
Remove locknut, washer, spring and the
bolt. See figure below.
Plastic Knob
(pointed forward)
Control
Panel
.3/8-16 Hex Jam Nut
Shifter Bracket
ocknut
Spring
1/8 to 3/8
inch of
Exposed
Thread