Craftsman 536.88123 - Manual (Page 8)

Position shifter iever assembiy as shown
in figure below.
'Shifter Bracket
Control Panel
• Reinstall bolt, spring, washer and locknut.
See last figure on page 7.
• Tighten locknut until 1/8 to 3/16 inch of
the bolt threads protrude past the locknut.
• Thread the 3/8-16" hex jam nut onto the
lever until the nut reaches the end of the
thread. See last figure on page 7,
• Thread the plastic knob as far as possible
and ensure that the knob points forward.
• Tighten the 3/8-16" hex jam nut against
the knob securely.
• Move shifter through all speeds to ensure
proper tension of the spring. If shifter
lever sticks in any of the notches, loosen
locknut 1/2 turn at a time until shifter lever
moves more freely.
REMOTE CHUTE CONTROL KNOB
• Thread the 3/8-16" hex jam nut onto the
lever until the nut reaches the end of the
thread. See figure below.
■ Thread the plastic knob as far as possible
and ensure tha the knob points forward.
• Tighten the 3/8-16" hex jam nut against
the knob securely.
HEADLIGHT
The headlight on your snowthrower is posi­
tioned in down position for packaging
purposes. Rotate upwards for operating po­
sition.
V CHECKLIST
Before you operate your new snow thrower,
to ensure that you receive the best perfor­
mance and satisfaction from this quality
product, please review the following
checklist:
V All assembly instructions have been
completed.
V The discharge chute rotates freely.
V No remaining loose parts in carton.
While learning how to use your snow
thrower, pay extra attention to the following
important items:
VV Engine oil is at proper level.
VV Make sure gas tank is filled properly
with clean, fresh, unleaded gasoline.
VV Become familiar with all controls-their
location and function. Operate controls
before starting engine.
Remote Chute