Assembly / pre-operation, To remove lawn mower from carton, How to set up your lawn mower – Craftsman 917.388111 User Manual

Page 6: To assemble grass catcher, To install attachments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

■I

I

ASSEMBLY / PRE-OPERATION

Read these instructions and this manual in

its entirety before you attempt to assemble
or operate your new lawn mower.
IMPORTANT: This lawn mower is shipped

WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been as­

sembled at the factory with the excep­
tion of those parts left unassembled for
shipping purposes. To ensure safe and

proper operation of your lawn mower, all
parts and hardware you assemble must be

tightened securely. Use the correct tools
as necessary to ensure proper tightness.

All parts such as nuts, washers, bolts, etc.,

necessary to complete the assembly have
been placed in the parts bag.

TO REMOVE LAWN MOWER FROM

CARTON

1. Remove loose parts included with

mower.

2. Cut down two end corners of carton

and lay end panel down flat.

3. Remove all packing materials except

padding between upper and lower

handle and padding holding operator

presence control bar to upper handle.

4. Roll lawn mower out of carton and

check carton thoroughly for additional

loose parts.

HOW TO SET UP YOUR LAWN
MOWER

TO UNFOLD HANDLE

IMPORTANT: Unfold handle carefully so

as not to pinch or damage control cables.

1. Raise handles until lower handle sec­

tion locks into place in mowing position.

2. Remove protective padding, raise up­

per handle section into place on lower

handle and tighten both handle knobs.

3. Remove handle padding holding

operator presence control bar to upper
handle.

Your lawn mower handle can be adjusted
for your mowing comfort. Refer to “AD­

JUST HANDLE” in the Service and Adjust­

ments section of this manual.

TO ASSEMBLE GRASS CATCHER

1. Put grass catcher frame into grass bag

with rigid part of bag on the bottom.

Make sure the frame handle is outside

of the bag top.

2. Slip vinyl bindings over frame.

NOTE; If vinyl bindings are too stiff, hold

them in warm water for a few minutes. If

bag gets wet, let it dry before using.

A / ^

Vinyl

bindings

Frame

handle

Frame

opening

TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to

be used as a mulcher. To convert to bag­
ging or discharging, see “TO CONVERT

MOWER” in the Operation section of this
manual.

388111-es-412691 rO.indd 6

%

2/23/2007 10:59:48 AM

Advertising